Whirlpool washer error codes: what each one means and what to check first.

Door switch error on front-load washers.

First check: Close the door completely and clear anything blocking the switch, then unplug the washer for 5 minutes.

The door is not locking properly.

First check: Re-close the door firmly, clear the opening, then unplug the washer for 5 minutes.

The door is not locking properly.

First check: Make sure nothing is blocking the latch, then unplug the washer for 5 minutes.

Drain time is longer than expected.

First check: Check the drain hose for kinks or a clog, use only HE detergent, then press Pause/Cancel or unplug for 5 minutes.

The washer is not draining correctly (long drain).

First check: Check the drain hose (no more than 4.5 in / 113 mm into the pipe, not taped in), then the pump filter and door seal holes.

The washer is not detecting the correct amount of incoming water.

First check: Press power and let the 8 to 10 minute drain routine finish, then check both valves, the hoses and the inlet screens.

Motor speed sensing error: the motor can’t reach the speed the cycle requires (front-load page).

First check: Make sure the shipping bolts and spacers are removed, then unplug the washer for 5 minutes.

A problem with the dispenser system.

First check: Check the detergent drawer or cartridge for a detergent clog (top-load bulk dispensers have their own checks).

Clothing was detected while the washer tried to run the Clean Washer cycle.

First check: Empty the drum completely and start Clean Washer again.

Items were detected in the drum during the Clean Washer cycle.

First check: Take everything out of the drum and restart Clean Washer; if it returns, unplug the washer for 5 minutes.